Much attention has been directed by the mill to the issue considering the quality of manufactured products , because the production volume and the amounts of the finished products being distributed to the places located thousands of kilometers away, make it impossible to do otherwise .
Our products are supplied mainly for the canned food products. Therefore, the enterprise has a system of serious incoming inspection of the incoming raw materials and the finished products.
During production of products we use only high-quality raw materials manufactured by Russian and foreign vendors, which isconfirmed by the quality documents, issued by the accredited certification authorities, such as the declarations of conformance, test reports and quality certificates.
All materials delivered to the mill are subject to the incoming inspection in our specially equipped laboratory to be checked for quality compliance according to GOST standards, technical specifications and other regulatory documents.
The quality control of the manufactured products is carried out at all production stages. The samples are selected by random sampling for passing of the preliminary inspection for resistance to the tests carried out in simulative environments. After manufacture, also by random sampling from the entire batch, our laboratory takes samples of the products for carrying out various tests. Only after the laboratory's confirmation of usability, the products may be shipped to the customer.
Thus, the mill has an entire production chain and a complex of measures to check the quality of the finished products, therefore the high-quality products are delivered to the buyer's warehouse just in time
Can

- Control of a seam quality (Calculation of overlapping area and seam thickness)
- Visual inspection (inspection for the presence of scratches, the weld joint or the seam)
- Checking of integrity of overlapping areas (air-tightness test)
- Control of stability of the paintwork by sterilization within the simulative environments
(3% of table salt, 2% of tartaric acid, 3% of acetic acid, distilled water, in the protein environments No. 1 and No. 2)
Lid

- Control of the amount of paste
- Geometrical measurements (dimensions, thickness)
- Checking of integrity of a varnish covering (for the presence of scratches)
- Control of stability of the paintwork by sterilization within the simulative environments
(3% of table salt, 2% of tartaric acid, 3% of acetic acid, distilled water, in the protein environments No. 1 and No. 2)
Lacquered tin in sheets
- Sheet metal thickness (shall be measured by micrometer)
- Lacquer thickness (shall be measured by the layer thickness meter)
- Scratching (measurement of the resistance to scratching)
- Adhesion (checking of the adjoining strength of paintwork, shall be checked by the adhesion tester and adhesive tape)
- Hardness (shall be measured by the special hardness gage in accordance with the Super-Rockwell system)
- Control of stability of the paintwork by sterilization within the simulative environments
White tin
Checking according to GOST 13345-85:
- Ridges of the sheets
- Nonsquareness of the sheets
- Hardness
- Detinning
Corrugated packaging

- Сorrugation type (the height and the corrugation pitch shall be measured)
- Double fold of the flaps
- Dimensions (length, width, height)
Laying

- Determination of size dimensions
- Determination of density